Harsh or bouncy over bumps: the order Öhlins gives for setting a shock
Öhlins' road and track shock manual sets sag first, then rebound and compression in two-click steps, with symptoms for each direction.
3 min readBy PitPin Desk
Öhlins' road and track shock manual starts with spring preload, because it affects the height of the bike and the fork angle. If the preload is set incorrectly, the manual says, no other adjustment will give the intended performance.
Sag before damping
On a flat surface, with both wheels off the ground on a stand, measure from a mark above the rear axle to the axle (R1), and from the upper triple clamp to the front axle (F1). Measure again with the bike on its wheels (R2, F2), then with you sitting on it in your riding gear (R3, F3). Unless the mounting instructions say otherwise, Öhlins recommends free sag (R1 minus R2) of 5 to 15 mm at the rear and 20 to 30 mm at the front, and ride height (R1 minus R3) of 25 to 35 mm at the rear and 30 to 40 mm at the front. If preload alone cannot reach those figures, you may need a softer or harder spring.
One short test run
Before riding, check that the basic settings made by Öhlins are still intact. Take a test ride with every adjuster at its recommended basic setting, on a short run with long and sharp bends and with hard and soft bumps. Stay on that run. Take notes, change one setting at a time, and keep the steps small. The recommended range is five clicks either side of the basic setting for both rebound and compression.
Rebound: packing down or nervous
Rebound damping controls how fast the shock returns after it has been compressed. If the spring, preload and ride height feel right, but the bike runs low and packs down over acceleration bumps, with the line lost or the comfort and traction lost, or both, open the rebound adjuster two clicks.
If the bike is nervous and moving a lot, or it feels high on corner entry, close the rebound adjuster two clicks. Then fine-tune one click at a time. Increase rebound when the bike feels unstable, loose or bouncy, and decrease it when the bike feels hard and bumpy.
Compression: soft or harsh
Compression damping controls how easily the shock compresses over a bump. If the bike feels soft and unstable and uses too much wheel travel, and the spring is right for you, close the compression adjuster two clicks. Öhlins says this controls the wheel more under acceleration, and it helps with ride height and with the shock falling through its stroke too quickly.
If the bike feels high, has poor grip when you open the throttle and feels unsmooth over small or medium bumps under acceleration, open the compression adjuster two clicks. On Öhlins' list, bottoming is another reason to increase compression, and a harsh, hard feel is a reason to decrease it.
Recheck and note conditions
When a change feels better, Öhlins says to go back to where you started and check again. Note other factors such as tyres and temperature. Öhlins says no setup is perfect on every track, so you will have to compromise, with priority on a safe feeling, stability and comfort.
Check the tyre first
In a ChampSchool clip, Brad Stokes of Öhlins USA says he does not necessarily agree that you can tune suspension from a photo of a worn tyre. Before adjusting suspension he looks at ambient and track temperature, the track, whether it was just resurfaced, tyre pressure and compound. At professional level, he says, a lot of the time unwanted tyre wear is usually down to tyre pressure, whether that pressure needs to go up or down.