Dave Moss: fix your timing and electronics before the clickers
Dave Moss in TrackDNA: clean up control timing and the electronics before the clickers. Don't check hot pressures before the third session, and only once you are within one to two seconds of your personal best.
3 min readBy PitPin Desk
Most track-day riders don't have a bike that is set up wrong, TrackDNA's Sean Beenaam writes after talking to Dave Moss. They work on things in the wrong order. Moss starts with control timing and the electronics, and leaves the clickers for later. Hot pressures wait until the third session, and until you are within one to two seconds of your personal best.
First-session timing
In a first session Moss looks for habits that create fake problems: a long coast before the brakes, two or three stabs at the brake inside the same braking zone, and on-and-off throttle on the way to the apex instead of one clear timing. "If you can't repeat the same input over the same distance, no setup is going to save you," he told TrackDNA.
Most of the time the rider has changed three things at once and then wants to blame the clicker. For him, suspension is innocent until proven guilty.
Ergonomics, sag and travel
His order is always the same: fit the rider to the bike (ergonomics), set sag, then check that fork and shock travel are used properly. Clickers come after that.
His basic framework records static and rider sag separately for fork and shock and aims for 30 to 33% of total travel. A cable tie on the right fork tube shows how much fork travel you use. A thin cable tie, or a light smear of grease, does the same on the shock shaft.
Hot pressures and the third session
If you ride five different laps in one session, you are measuring your own variability and blaming the bike for it. Until your pace settles, the pressure number doesn't really tell you anything.
In the pits, his advice is to set the first hot pressure of the day correctly for the time of day and the warmers you use, following the tyre maker's recommendations. Then leave it alone until your riding stabilises.
Electronics that feel like suspension
Traction control set too high cuts power and drive, and riders change shock preload and compression. ABS that is too aggressive can feel like chatter on the way into the corner, and riders change fork settings. Engine braking set too high can crush the forks on corner entry, and stiffening the fork only hides the real issue.
With high wheelie-control intervention, riders pin the throttle on exit and let the system save it, then soften the shock, chasing grip that isn't really a shock problem.
About ten minutes between sessions
The routine only takes about ten minutes: a photo of fork and shock travel, rpm on corner entry for gearing, and sector times against the previous session. He asks where the bike helps you and where you have to physically manipulate it, and wants that effort named: under braking, mid-corner or on exit, and whether it is consistent lap to lap or random.
Dead time between throttle and brake
On track, he wants riders to minimise the dead time between throttle and brake. The overlap just needs to be clean enough that your brake on-and-off zone matches what the tyre can handle.
Headshake on the front straight
One rider came to him with violent headshake on the front straight. The elbows were tucked in, the hands wrapped so they locked the bars. Moss moved the elbows out to rest outside the thighs, showed the "screwdriver" method for the throttle hand and optimised the throttle free play in the cable. The bike was not ride-by-wire. The headshake went away, and nothing on the bike had changed.