PitPinTrack day riders’ news & tips, pinned daily

Hanging off saves about 2.4° of lean per 10 cm, says Corner Speed

About 2.4° less bike lean per 10 cm you move your centre of mass inside, for a 75 kg rider on a 200 kg bike. The saving scales with your share of the weight, and stays almost exactly the same from 20° to 50°.

3 min readBy PitPin Desk

Moving your centre of mass 10 cm to the inside takes about 2.4° off the lean the bike needs, for a 75 kg rider on a 200 kg middleweight, with a combined centre-of-gravity height of 0.65 m. Twenty centimetres is worth 5.0° and 30 cm is worth 7.5°. The saving stays almost exactly the same from a relaxed 20° bend to a 50° corner at hard track pace, and it scales with your share of the weight.

An 80 m radius

At a fixed 40° of lean on an 80 m radius, the model gives 92 km/h with no body shift and 106 km/h with 30 cm inside.

Full hang-off and a knife-edge tyre

Thirty centimetres is a full racing hang-off, with the hips well off the seat and the torso dropped inside. This is a point-mass model with a knife-edge tyre. Real tyres are 120 to 200 mm wide, and as the bike leans the contact patch moves inboard and claws back some of the benefit, so Corner Speed says to treat the figures as the optimistic end.

Your share of the weight

You are the only part of the system that moves.

A 60 kg rider on a 220 kg tourer saves 1.9° per 10 cm.

A 75 kg rider on a 160 kg lightweight sports bike saves 2.9°.

A 90 kg rider on a 180 kg supersport saves 3.0°, more than half again the return of the 60 kg rider on the tourer, from exactly the same movement.

That is not a difference in skill, and no amount of practice closes it. If you are light and your bike is heavy, Corner Speed says, body position is a smaller lever for you than for the person telling you to use it. Vision, line and throttle control don't care what you weigh.

A relaxed road at 0.36 g

At a relaxed road pace of 0.36 g the bike needs 20° of lean, and a full hang-off would bring that to 12.7°. Both are so far from the ground clearance and grip limits of any modern motorcycle that the saving is worth precisely nothing in safety margin there.

Corner Speed's street version is to move the upper body and skip the hips: rotate your chest, drop your head inside, lock on with the outside leg and keep a light grip. That gives you a much better sightline through the bend and takes your weight off the bars. The full slide across the seat is for the track.

The one-corner test

Corner Speed's test is a corner you know, ridden twice at the same speed, with peak lean and speed logged for each corner. The phone is fixed to the bike's body. On the bars, vibration and the bar's own movement corrupt the reading. You sit centred and relaxed on the first pass, and use your normal cornering position on the second. Compare only passes whose average speeds are within a couple of km/h of each other. If the speeds differ, the comparison is meaningless.

What you are looking for is a drop of roughly 2° to 5° in peak lean, depending on how far you move and what you and the bike weigh. If peak lean is the same at the same speed, the movement is cosmetic, and the usual culprit is being crossed up, with the hips across but the head still over the tank.

Corner Speed says a track day, with the same corner a few dozen times and no oncoming traffic, is a far better laboratory than a public road.

Sources