PitPinTrack day riders’ news & tips, pinned daily

Night riding: the speed your low beam lets you stop in

Corner Speed puts the limit on a halogen low beam at about 48 mph (76 km/h) for a typical night rider on an unlit road. In bends the light runs out sooner.

3 min readBy PitPin Desk

On a halogen low beam on an unlit road, about 48 mph (76 km/h) is as fast as a typical night rider can go and still stop for a dark object within the lit distance. Corner Speed calculates that in its night-riding guide of 18 November. Its rule is never to ride faster than you can stop inside the distance your headlight lets you see.

How far a low beam reaches

The seeing distances come from AAA's 2015 headlight tests on unlit roads. A halogen reflector low beam shows a non-reflective object at about 300 ft (90 m). Projector halogen and HID units reach about 400 ft (120 m), and LED about 450 ft (140 m). Those were car headlamps. A single motorcycle headlight is usually the same or a bit shorter. Treat the figures as best-case numbers.

Signs and reflectors light up from much further away, which makes you think you can see further than you can. A dark deer, a black tyre tread or a pothole only shows up at the distances above.

High beam adds an average of 28% more forward reach, according to the same AAA report. Use it whenever nobody is coming towards you or riding close in front of you.

Stopping inside the beam

Corner Speed worked out stopping distances on a dry road at 0.6 g, a firm, well-practised stop on a modern bike with ABS. An alert rider takes 1.5 seconds to get on the brakes. A typical night rider takes 2.5 seconds, the reaction time US road design guidelines (AASHTO) assume.

At 50 mph (80 km/h) the night rider needs 323 ft (98 m) to stop, more than the 300 ft a halogen reflector shows. Even the alert rider, at 60 mph, needs more road than that beam lights.

The highest speed at which the night rider can stop within the low beam is about 48 mph (76 km/h) on a halogen reflector, 58 mph (93 km/h) on projector or HID, and 63 mph (101 km/h) on LED. Wet roads and cold tyres lower every figure.

A 50 m radius bend

The beam points along the bike's heading while the road curves away. On a 50 m radius bend at 37 mph (60 km/h), which needs 30° of lean, the point at the night rider's stopping distance sits 37° to the inside of the headlight. At 50 mph (80 km/h) and 45° of lean it is 56° to the inside, nearly round the corner. Night corner speed should fall more than straight-line speed does.

Visor and dash

Under ECE 22.06, a visor that lets through less than 80% of light is marked "daytime use only". Carry a clear one. Your eyes take 20 to 30 minutes to adapt fully to the dark. A glance at a bright phone or a full-brightness TFT dash undoes a lot of that. Switch the dash to its night or auto-dim mode. When an oncoming car is on high beam, look at the edge line on your side until it has passed.

Daylight lean and night lean

Compare the same road ridden by day and after dark. If your night lean angles in the same bends are as high as in daylight, Corner Speed says you are riding from memory rather than from what your headlight shows you.

Sources