PitPinTrack day riders’ news & tips, pinned daily

Eight degrees of lean, half the braking: finish stopping before you turn

Sport-bike tests cited by Corner Speed found the front locking at 0.32 to 0.39 g at 8 to 9° of lean, against 0.69 to 0.80 g upright.

2 min readBy PitPin Desk

Corner Speed's braking guide turns to a road with bends in it, and to how much braking grip is left once the bike leans.

Front lockup and lean angle

The guide cites Fatzinger and colleagues (2019), who braked sport bikes to the point of front-wheel lockup at different lean angles.

Upright, or within a couple of degrees of it, the front wheel let go somewhere between 0.69 and 0.80 g.

At 3 to 4° of lean the threshold was 0.51 to 0.67 g.

At 8 to 9° of lean it was 0.32 to 0.39 g.

Corner Speed takes the middle of the upright range as 0.75 g and the middle of the 8 to 9° range as 0.36 g. The guide reads the drop from 0.75 g to 0.36 g as more than half the braking already gone.

Eight degrees on the road

Eight degrees does not feel like cornering at all. The guide compares it to a lane change, drifting towards the apex of a motorway curve, or tipping into a roundabout. A real mountain-road corner, it says, is 25° to 40°, and by then the front tyre's entire grip budget is committed to turning, with very little left for stopping.

This is the physical basis for the old advice to get your braking done before you turn in. It is also why Corner Speed describes trail braking as releasing brake pressure as lean increases, not as carrying brake pressure into a corner.

ABS and cornering ABS

The guide says conventional ABS reads wheel speed only and is designed around upright braking. It does not know you are leaned, so if you grab the front brake at 30° of lean it will let you use more grip than the leaned tyre has, and you will still fall.

IMU-based cornering ABS, the guide says, does know the lean angle and limits brake pressure accordingly. The guide calls it a net under a mistake, and not permission to brake hard while leaned.

In an emergency

The order the guide gives: shut the throttle and get the bike upright and pointed straight first. Then take up the slack in the front brake lever with a quick initial squeeze that settles the fork, and build pressure progressively. Add light rear brake to keep the back end settled, and leave the clutch alone until you are near a stop.

Braking in a 30° corner

If your usual mountain-road corners show 30° or more on a lean-angle readout, any braking in there happens with roughly a third of your upright stopping power, by the guide's estimate. The guide's conclusion is to finish braking earlier, and it is not an argument for braking less.

Sources